Description
DimaFix Pen, Density (D) 0,8 g/cm³, Flash point (flp) >14 °C, Boiling point (bp) 78 °C, UN-Nr. 1133
Application
DimaFix Adhesive Pen - Good adhesion of your print to the print bed is a must in 3D printing! The DimaFix Adhesive Pen helps you to hold the object in place during printing and avoid so-called warping. The Dimafix Pen creates a strong bond between the first layer and the build plate when the bed is heated to 60ºC. Below 60ºC the bond dissolves so that prints can be easily removed from the build plate. Dimafix is completely water-soluble, so cleaning the building board is easy. The Dimafix pen can be used more than 100 times.
- Below 60ºC: Low adhesion, objects can be detached from the sheet.
- 60 - 75ºC: Medium adhesion, for simple geometries.
- 75 - 95ºC: High adhesion, for complex geometries and long prints.
- Above 95ºC: Very high adhesion, for very complex geometries and very long prints
Technical Information
| Type | DimaFix Pen |
Compliance & Safety Information
Danger
Hazard Statements (H-Phrases)
H225
Highly flammable liquid and vapour
H319
Causes serious eye irritation
Precautionary Statements (P-Phrases)
P102
P102 – No description available
P103
P103 – No description available
P210
Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.
P280
Wear protective gloves/protective clothing/eye protection/face protection.
P305+P351+P338
IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P337+P313
P337+P313 – No description available
P501
P501 – No description available